Sheets On The Ceiling

Cut and fold the fabric under inch at each edge.

Sheets on the ceiling. Measure the area you want to cover. Install beadboard ceiling panels in the same direction as your floor boards for visual continuity. Mark the grid on the ceiling the first step in laying out the grid work is to chalk lines around the perimeter of the room 4 1 2 inches away from the walls.

If wood chips fall out again you re joists are framed 12 on center. Then measure the length and width of the space inside. If your bed sheet is not the exact size you will need to cut it to fit your measurements.

That will allow the full 5 1 2 inch cap to fit against the wall and match the rest of the finished trim. Smooth the bed sheet against the wall at the top making sure to flatten and work out any creases or wrinkles. Apply tile or planks directly on your existing ceiling.

A standard 8 foot high wall accommodates two sheets of drywall installed horizontally. If wood chips fall out from the hole measure another 12 out from that 24 total from the wall and drill another hole. The panels come in two patterns.

Suitable for both sloped and flat ceilings the 4x8 ft tongue and groove sheets have a pine top veneer that s milled to look like bead board. Before cutting add 1 inch to the length and width of fabric you need. Tile and planks are great for covering damaged drywall or plaster popcorn ceilings.

Use the same procedure to attach this half piece of drywall as you used on the first row of drywall. Measure out 12 from the wall and drill a small hole into your ceiling. It also allows you to get a new surface without losing ceiling height.