Building A Bulkhead On A Ceiling

Snap a chalk line between the marks to lay out one edge of the sole plate.

Building a bulkhead on a ceiling. Bulkheads are typically used to conceal something. Put a mark on. Bulkhead kitchen cabinets using a miter saw cut the 2 by 4 inch lumber to the exact measurements that you need.

Cut one of the boards to the length measured in step 1 to create the top plate of the bulkhead. To enclose the kitchen a dropped ceiling provides a. For spans exceeding 1200mm a top cross rail is required to support the furring channel.

Hang a plumb bob from the nail and mark the floor at the point. To lay out the sole or floor plates of the new wall drive a nail into the ceiling close to one end of the chalk line. No additional support is required.

Justdoityourself lovingit perfecteverytime subscribe now and hit the bell to get notified about new videos https www youtube. Repeat at the other end of the ceiling chalk line. A bulkhead is a section of ceiling that has been dropped and boxed in or enclosed.

Clients frequently ask us about bulkheads and want to understand their purpose and here s our answer. It s important that you hit the studs and or ceiling joists with each nail as these nails will be supporting a significant amount of weight. It s not uncommon to have bulkheads in your kitchen bathroom or basement.

If you were to install the drywall mentally walk through where it would attach to the wall and the ceiling. Measure the length of where the bulkhead will be installed. If your bulkhead exceeds 600mm in width up to 1200mm furring channel trimmers can be placed at 600mm centers if using ceiling board or 450 centers if using standard plasterboard.